Juniper T640 - Figure 93: Console and Auxiliary Serial Port Connector; Figure 94: Console and Auxiliary Ports on the CIP

NOTE:
For console devices, configure the serial port to the following values:
•
Baud rate—9600
•
Parity—N
•
Data bits—8
•
Stop bits—1
•
Flow control—none
4. Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
5. Attach the other end of the cable to the console or auxiliary device.
Figure 93: Console and Auxiliary Serial Port Connector
Figure 94: Console and Auxiliary Ports on the CIP
Related
Documentation
Overview of Connecting the T640 Router to External Devices on page 209•
• Tools and Parts Required to Connect the T640 Router to External Devices on page 210
211Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Connecting the T640 to External Devices