3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
4. Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
handles on both sides of the LCC-CB faceplate.
5. Flip the ejector handles outward to unseat the LCC-CB.
6. Grasp the ejector handles and slide the LCC-CB about halfway out of the chassis.
7. Place one hand underneath the LCC-CB to support it and slide it completely out of
the chassis.
8. Place the LCC-CB on the antistatic mat.
9. If you are not replacing the LCC-CB now, install a blank panel over the empty slot.
Figure 147: Removing an LCC-CB
311Copyright © 2017, Juniper Networks, Inc.
Chapter 27: Replacing Host Subsystem Components
To Next Page
Loading...
Need help?
General
