slightly beneath the faceplate of the PIC. For a PIC installed in a Type 2 FPC or Type
3 FPC, use a narrow-ended tool that fits inside the opening that leads to the button.
•
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see request chassis pic.
The normal functioning status LED confirms that the PIC is online. You can also verify
correct PIC functioning by issuing the show chassis fpc pic-status command.
Figure 168: Installing a PIC
Related
Documentation
T640 Preventing Electrostatic Discharge Damage on page 506•
• T640 PIC Description on page 79
• Maintaining T640 PICs and PIC Cables on page 454
• Troubleshooting the T640 PICs on page 475
345Copyright © 2017, Juniper Networks, Inc.
Chapter 28: Replacing Line Card Components
To Next Page
Loading...
