NOTE: These procedures enable you to use the ETHERNET management
port. For the initial configuration, use a device attached to the CONSOLE port
on the CIP.
1.
Entering Configuration Mode on page 252
2.
Configuring User Accounts and Passwords on page 252
3.
Configuring System Attributes on page 253
4.
Committing the Configuration on page 254
Entering Configuration Mode
1. Verify that the network device is powered on.
2. Log in as the root user. There is no password.
Amnesiac <ttyd0>
login: root
3. Start the CLI.
root@% cli
root>
4. Enter configuration mode.
root> configure
Entering configuration mode.
[edit]
root#
Configuring User Accounts and Passwords
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see Configuring the Root Password and authentication.
1. Add a password to the root administration user account. Enter a clear-text password.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
2. Create a management console user account.
[edit]
root# set system login user user-name authentication plain-text-password
New Password: password
Retype new password: password
3. Set the user account class to super-user.
Copyright © 2017, Juniper Networks, Inc.252
T640 Core Router Hardware Guide
To Next Page
Loading...
Need help?
General
