To install the mounting hardware for an open-frame rack (see Figure 62 on page 164):
1. Install cage nuts, if needed, in the mounting holes specified in Table 88 on page 164.
2. On the rear of each rack rail, partially insert a mounting screw into the lowest hole
specified in Table 88 on page 164 for the large shelf.
3. Install the large shelf on the rack. Rest the bottom slot of each flange on a mounting
screw.
4. Partially insert screws into the open holes in the ears of the large shelf.
5. Tighten all the screws completely.
6. Remove the mounting brackets from the chassis by loosening the screws at the top
and bottom of each bracket.
The router is shipped with each spacer bar attached to the rear of each front-mounting
flange. Remove each spacer bar by removing the screws that fasten the spacer bar to
the front-mounting flange.
Figure 4 on page 16 shows the front-mounting flanges.
163Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Installing the Rack Mounting Hardware
To Next Page
Loading...
