4. Turn on the power to the external management device.
5. Switch on the dedicated customer site circuit breakers to provide power to the AC
power cables. Follow your site’s procedures.
6. Verify that the AC OK LED on both AC power supply faceplates are lit steadily green,
indicating that the power supplies are receiving power.
7. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
8. Switch the power switch on one of the power supplies to the ON position (|). The DC
OK LED blinks momentarily, then lights steadily.
NOTE: After a power supply is powered on, it can take up to 60 seconds
forstatusindicators—such asthe output status LEDs on the power supply,
the command output, and messages on the LCDon the craft interface—to
indicate that the power supply is functioning normally. Ignore error
indicators that appear during the first 60 seconds.
9. Verify that the DC OK LED on the AC power supply faceplate is lit steadily, indicating
that power supply is correctly installed, functioning properly, and providing power to
the DC outputs.
10. On the external management device connected to the Routing Engine, monitor the
startup process to verify that the system has booted properly.
NOTE: If the system is completely powered off when youpower on the power
supply, the Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting, you must power off the
router before powering it on again. After powering on a power supply, wait
at least 60 seconds before turning it off. After powering off a power supply,
wait at least 60 seconds before turning it back on.
Related
Documentation
T640 Three-Phase Delta and Wye AC Power Supply Description on page 106•
• Connecting AC Power to a T640 Router with Three-Phase Delta AC Power Supplies
on page 241
• Connecting AC Power to a T640 Router with Three-Phase Wye AC Power Supplies on
page 244
• Powering Off the T640 Router on page 248
247Copyright © 2017, Juniper Networks, Inc.
Chapter 22: Providing Power to the T640
To Next Page
Loading...
