4 CALibration Subsystem
220 N1911A/1912A P-Series Power Meters Programming Guide
– If this command is set to ON and TRIGger[SEQuence[1]|2]:COUNt is set to a
value >1, the error –221, “Setting conflict” occurs.
– If this command is set to ON (for dual channel, at either measurement channel)
when a P-Series power sensor is connected (for dual channel, at either
measurement channel) and is in the wait-for-trigger state for external trigger
buffering, the error –224, “Illegal parameter value” occurs.
To Next Page
Loading...
