2JZ/2JX/2JV/2H7
1-3-95
U246
Setting: [TURNED STAPLE HP ADJ]
1. Change the setting value using the +/- or numeric keys.
To increase the angle for slanted stapling (sample 1), decrease the preset value. To decrease the angle
for slanted stapling (sample 2), increase the preset value.
Figure 1-3-19
2. Press the start key. The value is set.
Method: [BOOKLET FOLDER]
1. Select the item to set. The screen for setting each item is displayed.
Setting: [WIDTH U HP ADJ/WIDTH L HP ADJ]
1. Select [WIDTH U HP ADJ] or [WIDTH L HP ADJ].
2. Change the setting value using the +/- or numeric keys.
3. Press the start key. The value is set.
4. Press the stop key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select [BOOKLET], then [WID A3 TEST].
The width guides of the center-folding unit will move to A3-size position.
6. Pull the center-folding unit, insert paper between the guides and check that paper is abut the guides.
7. Repeat the above adjustment until paper is properly in position.
Maintenance
item No.
Description
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of slanted stapling home position -10 to 10 0
0.99
°
Sample 1 Sample 2
Display Description
WIDTH U HP ADJ Adjustment of upper side registration home position
WIDTH L HP ADJ Adjustment of lower side registration home position
STAPLE POS ADJ (A4R/LTR) Adjustment of booklet stapling position for A4/Letter size
STAPLE POS ADJ (B4R/LGR) Adjustment of booklet stapling position for B4/Legal size
STAPLE POS ADJ (A3/LD) Adjustment of booklet stapling position for A3/Ledger size
SADDLE POS ADJ (A4R/LTR) Adjustment of center folding position for A4/Letter size
SADDLE POS ADJ (B4R/LGR) Adjustment of center folding position for B4/Legal size
SADDLE POS ADJ (A3/LD) Adjustment of center folding position for A3/Ledger size
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of upper side registration home position -20 to 20 0 0.104 mm
Adjustment of lower side registration home position -46 to 46 0 0.104 mm
To Next Page
Loading...
