2JZ/2JX/2JV/2H7-1
1-3-121
U464
Setting: [Set Sleep Period for Calib]
1. Change the setting value using the +/- or numeric keys.
2. Press the start key. The setting is set.
Setting: [Permission Act.(50sheets)]
1. Select ON or OFF.
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Permission (ON/Sleep out)]
1. Select ON or OFF.
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Permission (AP/NE)]
1. Select ON or OFF.
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [SetCalib Timing duringPrint]
1. Change the setting value using the +/- keys.
2. Press the start key. The setting is set.
Setting: [Set Interval CalibDriveTime]
1. Change the setting value using the +/- keys.
2. Press the start key. The setting is set.
Maintenance
item No.
Description
Display Description Setting range Initial setting
Time(min) Setting the standard time of sleep mode 0 to 480 (min) 60
Display Description
ON Enables permission to execute at continuously 50 pages
OFF Disables permission to execute at continuously 50 pages
Display Description
ON
Executes calibration if fuser temperature is less than 50
°C/122°F at
power-up or recovery from auto sleep mode
OFF Executes calibration regardless of fuser temperature at power-up or
recovery from auto sleep mode
Display Description
ON Paper interval calibration at the time of calibration/near end after
toner feed is carried out
OFF Paper interval calibration at the time of calibration/near end after
toner feed is not carried out
Display Description Setting range Initial setting
Timing(sec) Setting the drive standard time of contin-
uous print
300 to 3600 (s) 1800
Display Description Setting range Initial setting
Time(sec) Setting the drive standard time 300 to 3000 (s) 600
To Next Page
Loading...
