Kyocera TASKalfa 400ci - Page 166

2JZ/2JX/2JV/2H7-1
1-3-122
U464
Setting: [Set Interval CalibPrintRate]
1. Change the setting value using the +/- or numeric keys.
2. Press the start key. The setting is set.
Setting: [Set Custom]
1. Select ON or OFF.
Initial setting: OFF
2. Press the start key. The setting is set.
Setting: [AC Calibration]
1. Select ON or OFF.
2. Press ON/OFF. To turn on all items, select [ALL].
3. Press the start key. AC calibration is executed, and the execution result is displayed.
4. Turn the main power switch off and on.
Error codes
Completion
Press stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description Setting range Initial setting
Threshold Level(%) Setting the standard printing ratio 0 to 100 (%) 20
Display Description
ON Enables custom settings in setting the calibration cycle under the
machine defaults
OFF Disables custom settings in setting the calibration cycle under the
machine defaults
Display Description
CYAN
Developing unit C or drum unit C
MAGENTA Developing unit M or drum unit M
YELLOW Developing unit Y or drum unit Y
BLACK Developing unit K or drum unit K
Codes Description
0 Normally completed
11 Connector removed or failure of PWB (black)
12 Connector removed or failure of PWB (cyan)
13 Connector removed or failure of PWB (magenta)
14 Connector removed or failure of PWB (yellow)
15 Foreign matter in developing unit (black)
16 Foreign matter in developing unit (cyan)
17 Foreign matter in developing unit (magenta)
18 Foreign matter in developing unit (yellow)