Kyocera TASKalfa 400ci - Page 412

2JZ/2JX/2JV/2H7
2-3-44
YC7 1 REG_BP O 0/24 V DC (pulse) RM drive control signal
Connected
to the regis-
tration motor
and middle
motor (40/
40, 50/40
ppm model)
2 REG_AP O 0/24 V DC (pulse) RM drive control signal
3 REG_BN O 0/24 V DC (pulse) RM drive control signal
4 REG_AN O 0/24 V DC (pulse) RM drive control signal
5 ROL_BP O 0/24 V DC (pulse) MM drive control signal
6 ROL_AP O 0/24 V DC (pulse) MM drive control signal
7 ROL_BN O 0/24 V DC (pulse) MM drive control signal
8 ROL_AN O 0/24 V DC (pulse) MM drive control signal
YC7 1 LSU SOL DR O 0/24 V DC LSUCSOL: On/Off
Connected
to the LSU
cleaning
solenoid
(25/25, 30/
30 ppm
model)
2 +24V2 O 24 V DC 24 V DC power to LSUCSOL
YC8 A1 LFT1 MT SIG2 O 0/3.3 V DC LM1 paper gauge signal
Connected
to the
engine PWB
A2 LFT1 MT SIG1 O 0/3.3 V DC LM1 paper gauge signal
A3 LFT2 MT SIG2 O 0/3.3 V DC LM2 paper gauge signal
A4 LFT2 MT SIG1 O 0/3.3 V DC LM2 paper gauge signal
A5 LFT1 MT DR I 0/24 V DC LM1: On/Off
A6 LFT2 MT DR I 0/24 V DC LM2: On/Off
A7 LFT1 MT LOCK O 0/3.3 V DC LM1 lock signal
A8 LFT2 MT LOCK O 0/3.3 V DC LM2 lock signal
A9 CAS1LIFT UP O 0/3.3 V DC LSW1: On/Off
A10 CAS1 EMPTY O 0/3.3 V DC PSW1: On/Off
A11 CAS2 LIFT UP O 0/3.3 V DC LSW2: On/Off
A12 CAS2 EMPTY O 0/3.3 V DC PSW2: On/Off
A13 FED2 CLT REM I 0/24 V DC PFCL2: On/Off
A14 FEED MT CLK I 0/3.3 V DC (pulse) PCM clock signal
A15 FEED MT DIR I 0/3.3 V DC PCM drive switch signal
A16 FEED MT DR I 0/3.3 V DC PCM: On/Off
A17 FEED MT RDY O 0/3.3 V DC PCM ready signal
A18 DU MT DR I 0/3.3 V DC DUM: On/Off
A19 SENSOR FAN I 0/3.3 V DC LFM: On/Off
A20 DU MT CLK I 0/3.3 V DC (pulse) DUM clock signal
B1 DU MT PD I 0/3.3 V DC DUM current control signal
B2 CAS OPEN O 0/3.3 V DC LC2SW: On/Off
B3 FEED2 JAM O 0/3.3 V DC FSW2: On/Off
B4 FEED3 JAM O 0/3.3 V DC FSW3: On/Off
B5 DU JAM O 0/3.3 V DC DUSW: On/Off
B6 DU OPEN O 0/3.3 V DC LC1SW: On/Off
B7 COV FAN REM I 0/24 V DC PCFM1,2: On/Off
B8 JAM2 LED I 0/3.3 V DC JLEDPWB2 LED emitter signal
B9 JAM1 LED I 0/3.3 V DC JLEDPWB1 LED emitter signal
B10 DU ENTER JAM O 0/3.3 V DC FSSW: On/Off
Connector Pin No. Signal I/O Voltage Description