Lexmark 7462 series - Page 64

200 error messages
Error code Description Action
200.00 Sensor (input) area jam
The media is jammed in the sensor (input) area.
Go to
“Sensor (input) service check” on
page 70.
200.01 Sensor (input) lingering jam (MPF, duplex, or
envelope feeder)
The media reached the sensor (input) but did not
clear it within the specified time.
Go to
“Sensor (input) lingering jam service
check” on page 70.
200.02 Sensor (input) lingering jam
The media reached the sensor (input) but did not
clear it within the specified time.
200.04 Sensor (input) early jam
The media reached the sensor (input) sooner than
the specified time. Wrong config ID causes engine
to assume 500 paper path on 250 model.
Go to
“Sensor (input) early jam service check”
on page 72.
200.06 Sensor (input) early jam
The sensor (input) rebounded once the trailing
edge of the media passed.
Go to
“Sensor (input) service check” on
page 70.
200.07 Sensor (input) late area jam (input option tray)
The media is late reaching the sensor (input)
within the specified time.
Go to
“Sensor (input) late jam service check”
on page 73.
200.08 Sensor (input) early jam
The media reaches the sensor (input) sooner than
the specified time.
Go to
“Sensor (input) early jam service check”
on page 72.
200.09 Printhead laser start failure
The printhead laser start process failed because
it did not receive proper feedback signal from the
printhead motor.
Go to
“Printhead laser start failure service
check” on page 77.
200.10 Printhead motor synchronization error
The printhead motor is not synchronized when
media reaches the sensor (input).
200.11 Printhead polygon mirror synchronization error
The printhead polygon mirror motor becomes
unsynchronized when the media reaches the
sensor (input).
200.12 Laser power signal error
The printhead laser power signal has failed.
200.13 Sensor (input) static jam
Media remains on the sensor (input) during the
warm up sequence.
Go to
“Sensor (input) static jam service check”
on page 77.
200.14 Sensor (input) early jam
The media reaches the sensor (input) sooner than
the specified time.
Go to
“Sensor (input) early jam service check”
on page 72.
7462
Diagnostic information
64