Lexmark 7462 series - Page 65

Error code Description Action
200.15 Laser power did not settle.
Laser circuit failure on printhead or system card
assembly.
Go to
“Printhead laser start failure service
check” on page 77.
200.16 Main drive motor assembly load error
The main drive motor assembly has failed or
caused high mechanical load due to paper jam or
bind.
Go to
“Main drive motor assembly load error
service check” on page 80.
200.17 Sensor (input) lingering jam (tray 1 and tray level
not low)
The media reached the sensor (input) but did not
clear it within the
specified
time.
Go to
“Sensor (input) lingering jam service
check” on page 70.
200.18 Sensor (input) lingering jam (tray 1 and tray level
low)
The media reached the sensor (input) but did not
clear it within the specified time.
200.19 Sensor (input) lingering jam (tray 1 and tray level
empty)
The media reached the sensor (input) but did not
clear it within the specified time.
200.27 Sensor (input) lingering jam (tray 2 and tray level
not low)
The media reached the sensor (input) but did not
clear it within the
specified
time.
200.28 Sensor (input) lingering jam (tray 2 and tray level
low)
The media reached the sensor (input) but did not
clear it within the specified time.
200.29 Sensor (input) lingering jam (tray 2 and tray level
empty)
The media reached the sensor (input) but did not
clear it within the specified time.
200.32 Operator panel door assembly switch failure
Operator panel door assembly not fully closed.
Interlock switch not functioning correctly.
Go to
“Operator panel door assembly switch
failure service check” on page 81.
200.34 Sensor (toner empty) failure
The sensor (toner empty) has failed or is not
sensing the pulse wheel on the print cartridge.
Go to
“Sensor (toner empty) service check” on
page 82.
7462
Diagnostic information
65