5.1 Optional Programming
406 Optional Programming
02 1 If an outside party is transferred and
unanswered, assigns whether Transfer
Recall occurs at the transfer initiating
extension or at Operator 1.
0
: initiating
extension
1
: Operator 1
0 Call Transfer
2 If the restriction of outside call duration
is enabled in programme
[502] Extension-to-Outside Line Call
Duration Limit, assigns if the restriction
is done for both outgoing and incoming
calls or for outgoing calls only.
0
: both calls
1
: outgoing calls
only
0None
3 Allows you to remove confirmation tone
4. By default, a beep tone sounds when
a three-party conference is started /
ended.
0
: disable
1
: enable
1 Confirmation
Tone
4
Determines if the dialled " " and "#"
will be checked by Toll Restriction. This
assignment is required for certain
central offices (CO) to prevent toll
fraud. Some COs ignore the user-dialled
" " and "#". If your CO is such a type,
select "0" (no check).
0
: no check
1
: check
1 Toll Restriction
5 Reserved
6 Allows you to remove confirmation tone
3. This tone is sent when a conversation
is established just after dialling the
feature number for accessing the
following features: Call Pickup, Paging,
Paging Answer, TAFAS, Hold Retrieve
and Call Park Retrieve.
0
: disable
1
: enable
1 Confirmation
Tone
7 An outside line set to pulse or call
blocking mode in programme
[402] Dial Mode Selection can have
two settings. This assigns the pulse
break ratio during dial pulsing. Select an
appropriate ratio depending on the
standard in your country.
0
: 60 %
1
: 67 %
0 for
HK
1 for
Others
Dial Type
Selection
Explanation
Area Bit Description Selection Default Features Guide
References
To Next Page
Loading...
