Getting Started
R&S
®
SMW200A
104User Manual 1175.6632.02 ─ 30
5. Use the default mode, that is "Execution Mode > Interactive".
6. Tap on the "Start" button.
7. Observe the information displayed in the "Info" line (bottom of the display).
1 2 43
1 = Information on the performed action
2 = Progress bar
3 = "Next Step": confirms the execution of the step
4 = "Stop": terminates the tutorial
8. To execute a subsequent step, select the "Next Step" button.
A blinking cursor indicates the block or parameter affected by the step.
The instrument performs the configurations step-by-step and expects your confir-
mation. Dialogs are opened and closed; changed parameters are highlighted in
orange.
Additional information is displayed in the "Info" line.
To stop the tutorial
The demonstration can be terminated at any time.
► Select the "Stop" button.
The demonstration stops.
You can reopen the "Tutorials" dialog and start another file or exit the tutorial mode.
To use the demonstration mode
1. Start the tutorials as described in "To start a tutorial in an interactive step-by-step
mode" on page 102.
2. In the "Tutorials" dialog, select "Execution Mode > Auto (Looped) 3 sec".
The configurations are performed automatically; your interaction is not required.
Dialogs are opened and closed; changed parameters are highlighted in orange.
Additional information is displayed in the "Info" line.
Instrument Control
To Next Page
Loading...