Rohde & Schwarz R&S SMW200A - Analog Modulation Subsystems

Remote Control Commands
R&S
®
SMW200A
964User Manual 1175.6632.02 ─ 30
Return values:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See [:SOURce<hw>]:BBIN:OLOad:STATe? on page 963
Usage: Query only
Manual operation: See "Signal Monitoring" on page 165
[:SOURce<hw>]:BBIN:OLOad:HOLD:RESet
Reset of the Overload Hold indication.
Example:
see [:SOURce<hw>]:BBIN:OLOad:STATe? on page 963
Usage: Event
14.19.3 Analog Modulation Subsystems
The subsystems in this section describe all commands for analog modulation of the RF
signal. Divided in separate sections, you can configure amplitude modulation (AM), fre-
quency modulation (FM) , phase modulation (PhiM) and pulse modulation (PULM).
You can perform each of the modulations either with an internally generated modula-
tion signal or with an externally applied signal.
To configure the internal signal, use the commands listed in Chapter 14.19.11,
"SOURce:LFOutput Subsystem", on page 1152.
For more information:
See Chapter 8.8, "Analog Modulations", on page 529.
14.19.3.1 SOURce:MODulation Subsystem
The command in this subsytem allows you to disable all active modulations at once,
and, vice versa, to restore the last active ones.
[:SOURce<hw>]:MODulation[:ALL][:STATe] <State>
Activates all modulations that were active before the last switching off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
SOURce Subsystem