Rohde & Schwarz R&S SMW200A - File Select Settings

File and Data Management
R&S
®
SMW200A
686User Manual 1175.6632.02 ─ 30
Whenever a data list file is enabled as a data source, the instrument provides direct
access to the standard "File Select" function. This function enables you to select, cre-
ate and edit the data list files.
11.5.1 File Select Settings
The "File Select" dialog opens automatically each time you select a data list file as data
source or you select a control list.
To access a loadable data list file
1. Select the "Data List Name" in the individual dialog.
For "Baseband > 3GPP FDD > Base Stations > BS1 > Channel Table > P-CCPCH
> Data = Data List", for example, select "DList Patt = None".
A "File Select" dialog for loading, creating and modifying a file is displayed.
Tip: The name of the dialog is context-sensitive and differs depending on the par-
ticular function this dialog is from. However, the provided functions are similar.
2. To load an existing file:
Navigate through the file system.
Select the file and confirm with "Select".
3. To create a file, for example if there is no data list file specified:
Navigate through the file system.
Select "New" and specify the filename.
A new empty file is created and saved in the selected folder.
4. To edit an existing or newly created file:
Navigate through the file system.
Select the file and select "Edit".
The standard "Data List Editor" dialog opens
See Chapter 5.6.3.7, "Data List Editor", on page 279.
Accessing Files with User Data