Rohde & Schwarz R&S SMW200A - Apply; I;Q Stream Mapper Settings; Set to Default

Signal Routing and System Configuration
R&S
®
SMW200A
132User Manual 1175.6632.02 ─ 30
Set to Default
Presets the signal routing in the baseband section and the fading configuration to the
default state.
Note: Changing the system configuration triggers an instrument preset.
Remote command:
:SCONfiguration:PRESet on page 914
Apply
Triggers the instrument to adopt the selected configuration.
Note: Changing the system configuration triggers an instrument preset.
Note: The RF outputs are disabled, if you apply new System Configuration LxMxN
and/or change the Baseband Source Config.
Remote command:
:SCONfiguration:APPLy on page 919
Ok
Applies the configuration and exits the dialog.
Note: Changing the system configuration triggers an instrument preset.
Remote command:
:SCONfiguration:APPLy on page 919
4.4.2 I/Q Stream Mapper Settings
Access:
► In the block diagram, select "I/Q Stream Mapper".
Figure 4-7: Example: I/Q Stream Mapper settings in a LxMxN configuration with four streams
(standard baseband)
System Configuration Settings