File and Data Management
R&S
®
SMW200A
696User Manual 1175.6632.02 ─ 30
If the connection does not succeed, consider to check the following:
●
Is the network folder or computer you try to map turned on?
●
Is the network folder or computer enabled for remote access?
●
Does the selected user name have the necessary permissions?
See also Chapter 11.9.5, "Using a File Server for Test Files Exchange", on page 701.
11.9 How to Transfer Files from and to the Instrument
As explained in "File handling" on page 672, you access the file system of the
R&S SMW via one of the following ways:
●
Via the built-in "File Manager"
See Chapter 11.8, "Using the File Manager", on page 690.
●
On an instrument connected to a LAN:
– Via one of the standard functions ftp or SMB (samba)
See Chapter 11.9.2, "Accessing the File System of the R&S SMW via ftp",
on page 698 and
Chapter 11.9.3, "Accessing the R&S SMW File System via SMB (Samba)",
on page 699
– Via mapped network drives
See Chapter 11.8.4, "How to Map a Network Folder", on page 694.
●
Via a connected USB storage device
See Chapter 11.9.4, "Using a USB Storage Device for File Transfer", on page 701
Mainly because of security reasons, the access to the file system of your R&S SMW
can be denied, because one or all these access methods are deliberately disabled.
Access to the file system via LAN and/or USB requires that the corresponding service
is enabled and a write access to the file system is enabled. Refer to Chapter 11.9.1,
"Removing File System Protection", on page 697 for description of the required steps.
How to Transfer Files from and to the Instrument
To Next Page
Loading...