Rohde & Schwarz R&S SMW200A - Baseband and Fading Configuration

Remote Control Commands
R&S
®
SMW200A
914User Manual 1175.6632.02 ─ 30
Manual operation: See "State" on page 642
:SCONfiguration:MULTiinstrument:TRIGger:SYNChronization?
Queries if synchronization is achieved.
Return values:
<SyncSTate> SYNC | NOSYnc
*RST: NOSYnc
Example: See Example "Configuring primary-secondary mode"
on page 907.
Usage: Query only
Manual operation: See "Synchronisation State" on page 642
14.18.2 Baseband and Fading Configuration
:SCONfiguration:PRESet................................................................................................ 914
:SCONfiguration:MODE..................................................................................................914
:SCONfiguration:OUTPut:MODE..................................................................................... 915
:SCONfiguration:FADing................................................................................................. 916
:SCONfiguration:MIMO:SUBSet.......................................................................................917
:SCONfiguration:BASeband:SOURce...............................................................................917
:SCONfiguration:BBBW.................................................................................................. 917
:SCONfiguration:CABW?................................................................................................ 918
:SCONfiguration:DIQ:BBMM1:CHANnels..........................................................................918
:SCONfiguration:DIQ:BBMM2:CHANnels..........................................................................918
:SCONfiguration:DUPLicate[:STReam].............................................................................919
:SCONfiguration:APPLy..................................................................................................919
:SCONfiguration:PRESet
Presets the signal routing in the baseband section and the fading configuration to the
default state.
Example:
See Example "Distributing the I/Q streams to the output connec-
tors" on page 904.
Usage: Event
Manual operation: See "Set to Default" on page 132
:SCONfiguration:MODE <Mode>
Switches between the operating modes.
Parameters:
<Mode> ADVanced | STANdard | REGenerator | GNSS | ESEQuencer
SCONfiguration Subsystem