Rohde & Schwarz R&S SMW200A - AWGN Test Signal

Configuring the Internal Baseband Source
R&S
®
SMW200A
349User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:DVB:NOTCh<ch>:BWIDth[:ABSolute] on page 1060
[:SOURce<hw>]:BB:EUTRa:NOTCh<ch>:BWIDth[:ABSolute] on page 1060
[:SOURce<hw>]:BB:OFDM:NOTCh<ch>:BWIDth[:ABSolute] on page 1060
[:SOURce<hw>]:BB:ONEWeb:NOTCh<ch>:BWIDth[:ABSolute] on page 1060
Notch Bandwidth /% ← Notch definition table
Sets the notch bandwidth relative to Clock Frequency.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:NOTCh<ch>:BWIDth:RELative on page 1061
etc. for the corresponding option:
[:SOURce<hw>]:BB:DVB:NOTCh<ch>:BWIDth:RELative on page 1061
[:SOURce<hw>]:BB:EUTRa:NOTCh<ch>:BWIDth:RELative on page 1061
[:SOURce<hw>]:BB:OFDM:NOTCh<ch>:BWIDth:RELative on page 1061
[:SOURce<hw>]:BB:ONEWeb:NOTCh<ch>:BWIDth:RELative on page 1061
Apply
Select "Apply" to adopt the configured settings.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:NOTCh:APPLy on page 1061
etc. for the corresponding option:
[:SOURce<hw>]:BB:DVB:NOTCh:APPLy on page 1061
[:SOURce<hw>]:BB:EUTRa:NOTCh:APPLy on page 1061
[:SOURce<hw>]:BB:OFDM:NOTCh:APPLy on page 1061
[:SOURce<hw>]:BB:ONEWeb:NOTCh:APPLy on page 1061
5.8.4 AWGN Test Signal
Option: R&S SMW-K811.
See also Chapter 5.8.1, "Required Options", on page 345.
Access:
► Select "Baseband > ARB > General > Test Signal Form > AWGN".
The remote commands required to define these settings are described in Chap-
ter 14.19.4.3, "SOURce:BB:ARBitrary Subsystem", on page 1019.
To generate an AWGN test signal
1. Select "Test Signal Form > AWGN".
2. Click "Create Test Signal".
The dialog "AWGN Test SIgnal" opens. Optionally, adjust the number of samples of
the test signal.
Generating Notched Signals