Rohde & Schwarz R&S SMW200A - Source:sweep Subsystem

Remote Control Commands
R&S
®
SMW200A
1205User Manual 1175.6632.02 ─ 30
Return values:
<Level> float
Increment: 0.01
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "Level" on page 660
:SOURce<hw>:RFALignment:CORRection:IQDelay?
Queries the I/Q delay applied for compensation of the frequency response of the sig-
nal.
Return values:
<IQdelay> float
Increment: 1E-12
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "I/Q Delay" on page 660
14.19.19 SOURce:SWEep Subsystem
The SOURce:SWEep subsystem contains the commands for configuring RF sweep sig-
nals.
●
The keyword [:FREQuency] can be omitted, then the commands are SCPI-com-
pliant.
●
To activate an RF sweep mode, use the following commands:
– RF frequency sweep: SOURce:FREQuency:MODE SWEep
(SOURce:FREQuency:MODE CW (off))
– RF level sweep:SOURce:POWer:MODE SWEep (SOURce:POWer:MODE CW
(off))
– RF combined sweep: SOURce:FREQuency:MODE SWEep
(SOURce:FREQuency:MODE CW (off)
●
All sweeps, including the LF sweep, can be set independently of each other.
●
All sweeps can be set independently of each other.
See Chapter 8.7.1, "Signal Generation and Triggering in the Sweep and List Modes",
on page 493.
SOURce Subsystem