Rohde & Schwarz R&S SMW200A - Appearance Settings

General Instrument Functions
R&S
®
SMW200A
711User Manual 1175.6632.02 ─ 30
The remote commands required to configure the display and keyboard are described in
Chapter 14.12, "DISPlay Subsystem", on page 874 and Chapter 14.15, "KBOard Sub-
system", on page 884.
Screen Saver...............................................................................................................711
Wait Time.....................................................................................................................711
USB Keyboard > Layout..............................................................................................711
Screen Saver
Activates the screensaver.
If activated, the display including backlight is switched off after the selected Wait Time
elapses and if no entries via touch panel, front panel, external mouse, or external key-
board are made
Remote command:
:DISPlay:PSAVe[:STATe] on page 875
Wait Time
Enters the idle time that must elapse before the display lamp is shut off when no
entries are made.
Remote command:
:DISPlay:PSAVe:HOLDoff on page 875
USB Keyboard > Layout
Selects the language of an externally connected keyboard via USB. The function
assigns the corresponding keys automatically.
Remote command:
:KBOard:LAYout on page 884
12.1.2 Appearance Settings
Access:
► Select "System Config > Setup > User Interface > Appearance".
In this dialog, you can set inactive dialog opaque and enable the display of dialog
snapshots.
Display Dialog Snapshots............................................................................................711
Display Dialog Snapshots
Displays thumbnails of open dialogs in the task bar.
Customizing the User Interface