Configuring the Internal Baseband Source
R&S
®
SMW200A
305User Manual 1175.6632.02 ─ 30
Waveforms table
If the current instrument configuration uses Coupled sources, the dialog displays a
table with of up to 8 rows, where the number of rows corresponds to the number of
selected BB Signals (Tx Antennas) or Entities (Users, Cells).
The waveforms table consists of one row only, if the parameter Use one Waveform for
all basebands is enabled.
Following parameters are available per baseband:
●
Clock Frequency
●
Delay
●
File
●
Waveform Info
Load Waveform/File
Accesses the standard "File Select" function of the instrument. The provided navigation
possibilities in the dialog are self-explanatory.
The waveform files are files with predefined file extension *.wv. When a file is
selected, the dialog displays short information about the selected waveform.
Enable the ARB generator ("ARB > State > On") to trigger the instrument to load and
process the selected waveform file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect on page 1034
Waveform Info
Opens a dialog with detailed information about the currently selected waveform. The
display depends on whether the selected waveform file is a multi-segment one or not.
All parameters are read-only.
Remote command:
For non-multi segment waveform files, use the Tag commands (see Chapter 5.7.5,
"Tags for Waveforms, Data and Control Lists", on page 327).
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...