Rohde & Schwarz R&S SMW200A - Network Operation and Remote Control; Overview of Remote Access Modes

Network Operation and Remote Control
R&S
®
SMW200A
773User Manual 1175.6632.02 ─ 30
13 Network Operation and Remote Control
The description in this section requires basic knowledge of the remote control opera-
tion. Definitions specified in the SCPI standard are not provided.
You find some basic information to the SCPI syntax, command lists, and general pro-
gramming recommendations in Chapter D.1, "Additional Basics on Remote Control",
on page 1314.
See also Chapter D.1.5, "Status Reporting System", on page 1327.
As an alternative to the interactive operation directly at the instrument, you can operate
the R&S SMW also from a remote location.
The Figure 13-1 shows the possibilities of the physical connection (interfaces) for the
remote access.
Figure 13-1: Supported remote connections
The various interfaces provide flexible access to the instrument, such as
remote con-
trol, remote operation or remote file access. These remote access modes are funda-
mentally different, although they are often considered interchangeable.
See:
●
Overview of Remote Access Modes
●
1GP72: Connectivity of Rohde&Schwarz Signal Generators
●
Chapter 3.1.7, "Connecting to LAN", on page 31
13.1 Overview of Remote Access Modes
This section outlines the possible access modes and their major characteristics.
Overview of Remote Access Modes