Rohde & Schwarz R&S SMW200A - Impulsive Noise Settings

Simulating Fading, Adding Noise and Predistortions, and Impairing the Signal
R&S
®
SMW200A
435User Manual 1175.6632.02 ─ 30
●
pll1.fcf
●
pll2.fcf
6.3.4 Impulsive Noise Settings
You can generate impulsive noise in the following configurations:
●
Option: R&S SMW-B10
– "System Config > Fading/Baseband Config > Mode = Standard"
– "System Config > Fading/Baseband Config > Mode = Advanced" with up to 4
streams
●
Option: R&S SMW-B9
– "System Config > Fading/Baseband Config > Mode = Standard" with "Signal
Outputs = Analog Only"
– "System Config > Fading/Baseband Config > Mode = Advanced".
For more information, see data sheet.
Access:
1. Select "AWGN > Config > Impulsive Noise".
2. To start impulsive noise generation with the default settings, select "State > On".
3. Close the dialog and observe the incitation on the block diagram.
The label in the AWGN block ("Ipls" or "I") changes to reflect that the impulsive
noise generation is activated.
The remote commands required to define these settings are described in Chap-
ter 14.19.13.2, "Impulsive Noise Commands", on page 1182.
Generating Impulsive and Phase Noise