Rohde & Schwarz R&S SMW200A - How to Verify the Generated Signal with the Graphics Display

Monitoring Signal Characteristics
R&S
®
SMW200A
611User Manual 1175.6632.02 ─ 30
9.1.5 How to Verify the Generated Signal with the Graphics Display
This section shows you how to use the different graphic modes to visualize the signal
characteristics of the generated signal. It shows also how to observe the effect of stan-
dard settings, like applied filter, an enabled fading or AWGN. The examples use a sim-
ple custom digital modulated signal.
To generate a simple WCDMA-3GPP (QPSK 45° offset) signal
► Use the custom digital modulation. Enable a predefined WCDMA-3GPP signal.
For more information, see Chapter 3.3.2, "Generating a Digitally Modulated Sig-
nal", on page 55.
Figure 9-11: Used modulation type
Configure the graphical signal display
1. Select the wave icon:
The "Graphics Configuration" dialog opens.
Displaying Baseband Signal Characteristics in Real-Time