Rohde & Schwarz R&S SMW200A - MWV_SEGMENT_CLOCK_MODE: Mode; MWV_SEGMENT_DURATION: Segdur0, Segdur1; MWV_SEGMENT_LENGTH: Samplesseg0, Samplesseg1; Mwv_Segment_Start

Configuring the Internal Baseband Source
R&S
®
SMW200A
338User Manual 1175.6632.02 ─ 30
{MWV_SEGMENT_DURATION: SegDur0, SegDur1, …, SegDurN-1}
(optional for multi-segment waveforms)
The tag gives the time duration (in seconds) per segment.
Example:
{MWV_SEGMENT_DURATION: 1,0.5}
Multi-segment waveform with 2 segments, lasting 1 s and 0.5 s
each.
Usage: Setting only
{MWV_SEGMENT_LENGTH: SamplesSeg0, SamplesSeg1, …, SamplesSegN-1}
(mandatory for multi-segment waveforms)
The tag contains a list of I/Q sample lengths for every segment in the multi-segment
waveform in ASCII integer format.
Example:
{MWV_SEGMENT_LENGTH: 100,200}
2 segments: 100 samples in segment 0 and 200 samples in seg-
ment 1.
Usage: Setting only
{MWV_SEGMENT_START:
SampleStartOffsetSeg0, SampleStartOffsetSeg1, …, SampleStartOffsetSegN-1}
(mandatory for multi-segment waveforms)
The tag contains a list of I/Q sample start offsets for every segment in the multi-seg-
ment waveform in ASCII integer format.
Example:
{MWV_SEGMENT_START: 0,100}
2 segments with 100 samples in segment 0 and 200 samples in
segment 1.
The start offset of first segment is 0 samples, start offset of next
segment 1 is the sample length of segment 0 = 100 samples.
Usage: Setting only
{MWV_SEGMENT_CLOCK_MODE: Mode}
(mandatory for multi-segment waveforms)
The tag contains a string in ASCII format which supplies the clock rate mode, that was
used for calculation of the multi-segment output waveform (see also "Clock"
on page 364).
Using the Arbitrary Waveform Generator (ARB)