Signal Routing and System Configuration
R&S
®
SMW200A
129User Manual 1175.6632.02 ─ 30
Number of entities (L) Number of base-
bands (Tx antennas)
(M)
Number of streams
(Rx antennas)
(N)
Baseband Source Config
2 1, 2 1 to 4 Separate, Coupled/Coupled
per entity
2 1 to 4 1, 2 Coupled/Coupled per entity
3 to 4 1, 2 1, 2 Coupled/Coupled per entity
5 to 8 1 1 Coupled
See also "To simulate complex MxN MIMO scenarios using the "Fading and Baseband
Configuration" settings" on page 191.
Tip: Use the "System Configuration > Overview" tab to visualize the current stream
mapping to the output interfaces.
Remote command:
See :SCONfiguration:FADing on page 916
BB Signals (Tx Antennas) ← System Configuration LxMxN
Defines the number of baseband signals or Tx antennas to be simulated per entity. If
one entity is enabled, the R&S SMW can generate the signal of up to 8 Tx antennas
simultaneously (see Table 4-6).
Configurations with "BB Signals (Tx Antennas) > 4" are enabled only with internal
baseband signal.
Note: Error message: "The selected configuration is not fully supported by the current
firmware".
Some baseband and fading configurations require that the R&S SMW is equipped with
hardware and software options or the selected configuration is not yet fully supported.
For more information, refer to the instrument's data sheet.
Remote command:
See :SCONfiguration:FADing on page 916
Streams (Rx Antennas) ← System Configuration LxMxN
Defines the number of streams or Rx antennas to be generated per entity. If one entity
is enabled, the R&S SMW can generate the signal of up to 8 Rx antennas simultane-
ously (see Table 4-6).
Remote command:
See :SCONfiguration:FADing on page 916
Subset
Available if 1x8x8 configuration is selected.
System Configuration Settings
To Next Page
Loading...