Rohde & Schwarz R&S SMW200A - Source Subsystem

Remote Control Commands
R&S
®
SMW200A
944User Manual 1175.6632.02 ─ 30
EXTernal
The instrument uses an external reference frequency source, for
example from other R&S SMW (the one with
SCONfiguration:RFALignment:SETup:INFO:WIRing:
REF:SOURce PRIMary) or from R&S
®
SMA100B.
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "Ref Configuration > Signal Source" on page 661
14.19 SOURce Subsystem
The SOURce subsystem contains the commands for configuring digital and analog sig-
nals.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
ENTity<ch>
1 to 4 Entity in a multiple entity configuration
SOURce<hw>
[1] to 8 Baseband signals/paths
●
SOURce[1] = Path A/Baseband A
(optional keyword and suffix)
●
SOURce2 = Path B/Baseband B
(mandatory keyword and suffix)
●
LF output = SOURce:LFOutput
(SOURce is optional keyword)
OUTPut<ch>
[1] to 3 Available markers
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
See also Chapter 14.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 842.
● Connector Settings................................................................................................945
● SOURce:BBIN Subsystem....................................................................................954
● Analog Modulation Subsystems............................................................................964
● SOURce:BB Subsystem....................................................................................... 984
● SOURce:CORRection Subsystem...................................................................... 1114
● SOURce:FREQuency Subsystem.......................................................................1124
● SOURce:FREQuency:CONVerter Subsystem.................................................... 1133
● SOURce:INPut Subsystem................................................................................. 1135
● SOURce:IQ Subsystem.......................................................................................1136
● SOURce:IQ:OUTPut Subsystem.........................................................................1139
● SOURce:LFOutput Subsystem........................................................................... 1152
SOURce Subsystem