Rohde & Schwarz R&S SMW200A - Source:input Subsystem

Remote Control Commands
R&S
®
SMW200A
1135User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:MIN?
Indicates the minimum frequency value of the connected R&S SZU.
The frequency overrange is based on the calibration data of the specific device.
Return values:
<OverrangMinFreq> float
Range: OverrangeMin to OverrangeMax
Increment: 0.01
*RST: OverrangeMin
Example: See Example "Querying the frequency overrange provided by an
R&S SZU100A IQ Upconverter" on page 1134
Usage: Query only
Manual operation: See "Minimal Frequency" on page 465
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange[:STATe]
<OverrangState>
Enables the extended frequency range of a connected R&S SZU.
Parameters:
<OverrangState> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Querying the frequency overrange provided by an
R&S SZU100A IQ Upconverter" on page 1134
Manual operation: See "Frequency Overrange Active" on page 464
14.19.8 SOURce:INPut Subsystem
The SOURce:INPut subsystem contains the commands for configuring the inputs for
external modulation signals. The instrument trigger setting influences all sweeps and is
effective in the List mode (Instrument Trigger).
[:SOURce<hw>]:INPut:MODext:COUPling<ch>...............................................................1135
[:SOURce<hw>]:INPut:MODext:IMPedance<ch>.............................................................1136
[:SOURce<hw>]:INPut:TRIGger:SLOPe......................................................................... 1136
[:SOURce<hw>]:INPut:MODext:COUPling<ch> <Coupling>
Selects the coupling mode for an externally applied modulation signal.
Parameters:
<Coupling> AC | DC
AC
Passes the AC signal component of the modulation signal.
SOURce Subsystem