Getting Started
R&S
®
SMW200A
71User Manual 1175.6632.02 ─ 30
6. In the "Power Spectrum" dialog, select "Configure" to return to the "Graphics Con-
figuration" dialog.
Close the "Graphics Configuration" dialog.
This action has no effect on the configured graphics but on the dialog itself.
The block diagram displays the current signal routing. It indicates that frequency
and power offsets are enabled and displays the acquisition points for the real-time
diagrams minimized in the "Taskbar".
See also Chapter 9, "Monitoring Signal Characteristics", on page 597.
3.3.7 Saving and Recalling Settings
To restore the results of our measurements later, we saved the instrument settings to a
file.
To save instrument settings to a file
We assume, a test configuration as described in Chapter 3.3.5, "Routing a Baseband
Signal to the Outputs", on page 64.
1. Press the [SAVE/RCL] key on the front panel.
2. In the "Save/Recall" dialog box, select "Operation Mode > Save".
Tap the "Filename", use the on-screen keyboard, and enter MyTestSignal.
Trying Out the Instrument
To Next Page
Loading...