Signal Routing and System Configuration
R&S
®
SMW200A
178User Manual 1175.6632.02 ─ 30
4.7.2 Channels Settings
Option: R&S SMW-B9/-K19
Access:
1. Select "System Config > Fading/Baseband Config > Signal Outputs" = "Digital
Only (HS)".
2. Set the number of channels per HS DIG I/Q interface, where the total number of
channels on all interfaces cannot exceed eight.
For example, for "HS Cannels per > BBMM1" set "Channels = 4".
3. Select "I/Q Digital > I/Q Digital Settings > Channels".
The dialog consists of two tabs on the side, of per digital output interface HS DIG I/Q.
The tab name displays the output interface the settings are related to and an overview
information on the streams mapped to the particular connector.
The channels are displayed in table form, where the number of rows corresponds to
the number of channels per interface as set with the parameter HS Channels per
BBMMx.
Number
Subsequent number.
Name
Sets the name of the channel of the used interface.
The default channels naming syntax is <interface name>_CH<channel number>
but you can change it if necessary.
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:CHANnel<st0>:NAMe on page 1151
Stream
Indicates the streams that are routed to the channel.
To change the routing, use the "I/Q Stream Mapper".
Sample Rate
Sets the sample rate per channel.
I/Q Digital Output Settings
To Next Page
Loading...