Rohde & Schwarz R&S SMW200A - Accessing the Functions in the Baseband Domain

Configuring the Internal Baseband Source
R&S
®
SMW200A
219User Manual 1175.6632.02 ─ 30
●
Advanced receiver testing of wideband radar modules
●
Multicarrier signal with a bandwidth of up to 2 GHz
●
Wideband signals also in the microwave range
Where to find related information
This description assumes a fully equipped Standard baseband R&S SMW, so that we
can explain all instrument concepts and show the possible configuration and settings. If
a particular function requires a special option, this option is stated in the list of the
required options.
If your instrument is equipped with Wideband baseband generator, some sections of
this description are not relevant. Refer to the list of required options in the correspond-
ing section to check if the description applies in your case.
Note that the values ranges in the remote control commands correspond to a Standard
baseband instrument.
5.3 Accessing the Functions in the Baseband Domain
1. In the block diagram, select the "Baseband" block and navigate through the context
menu.
The "Baseband" block comprises all functions and settings concerning the base-
band signal. The functions and settings include all generation modes as described
in the Chapter 5.1, "Overview of the Signal Generation Modes", on page 216.
2. By default, baseband signal generation is off.
To activate the baseband generator, in the block diagram, select the "Baseband"
block and set "Baseband > On".
A short designation indicates the digital standard or modulation currently selected.
Accessing the Functions in the Baseband Domain