Rohde & Schwarz R&S SMW200A - Display and Keyboard Settings

General Instrument Functions
R&S
®
SMW200A
710User Manual 1175.6632.02 ─ 30
you can turn off this function to reduce settling times when the instrument is remote
controlled.
We recommend that you switch off the display update for optimum sweep performance
with short dwell times and for fast settling times.
Consider that in this case the displayed values can differ from the operated values.
In detail described in the following paragraphs, you can:
●
Set display and keyboard language, see Chapter 12.1.1, "Display and Keyboard
Settings", on page 710
●
Customize the GUI appearance, see:
– Dialog snapshots
– Chapter 12.1.2, "Appearance Settings", on page 711
●
Set date and time for the system clock, see Chapter 17.3.1, "Date and Time",
on page 1272
●
Configure and activate a Screen Saver
●
Deactivate display update to improve performance, see Chapter 12.1.3, "Display
Update Settings", on page 712
●
Determine the state of the RF signal, and the level display in the status bar when
you turn on the R&S SMW, see Chapter 12.1.4, "Defining the RF Signal State On
Power On", on page 712.
12.1.1 Display and Keyboard Settings
Access:
1. Select "System Config > Setup > User Interface > Display/Keyboard > Display".
2. Select "Display/Keyboard > USB Keyboard".
In the "Display/Keyboard" dialog, you can change regional and language options
for the GUI and an external keyboard, and define the screen saver settings.
Customizing the User Interface