Maintenance, Storage and Disposal
R&S
®
SMW200A
1272User Manual 1175.6632.02 ─ 30
When to run selftest?
We recommend that you perform a selftest, if the instrument does not respond as
expected.
How to: See Chapter 17.3.4.4, "How to Set Up the R&S SMW for BNC Connections
Tests", on page 1287.
● Date and Time.....................................................................................................1272
● Check Front Panel.............................................................................................. 1274
● Internal Adjustments........................................................................................... 1279
● Selftest................................................................................................................ 1283
● FPGA/uC Update Settings.................................................................................. 1287
17.3.1 Date and Time
The R&S SMW uses an internal real-time clock to determine the date and time. It
adjusts the time and date to the timezone of your location automatically, by providing a
selection list of continents and cities.
The instrument records the time whenever you create or modify files on your instru-
ment or you use timed licenses. By default, the instrument is set to the UTC timezone,
but you can select the timezone according to your location.
Moreover, the instrument supports NTP protocol for synchronizing all connected instru-
ments and computer systems to minimize time delays in the network.
17.3.1.1 Data and Time Settings
Access:
► Select "System Config > Setup > Maintenance > Date / Time".
The "Date / Time" dialog contains the time and data settings of the operating sys-
tem.
This function is password-protected. Unlock the protection level 1 to access it.
Performing Maintenance Tasks
To Next Page
Loading...