Rohde & Schwarz R&S SMW200A - Source:list Subsystem

Remote Control Commands
R&S
®
SMW200A
1164User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
<Logarithmic>
Sets the step width factor for logarithmic sweeps to calculate the frequencies of the
steps.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode",
on page 501
Parameters:
<Logarithmic> float
The unit is mandatory
Range: 0.01 to 100
Increment: 0.01
*RST: 1
Default unit: PCT
Example: See Example "Setup an LF sweep" on page 1152.
Manual operation: See "Step Linear/Step Logarithmic" on page 514
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for the linear sweep.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode",
on page 501
Parameters:
<Linear> float
Range: 0.1 to STOP-STARt
Increment: 0.1
*RST: 1000
Example: See Example "Setup an LF sweep" on page 1152.
Manual operation: See "Step Linear/Step Logarithmic" on page 514
14.19.12 SOURce:LIST Subsystem
The SOURce:LIST subsystem contains all commands for defining lists and for han-
dling of list files.
List files have the predefined file extension *.lsw.
Refer to Chapter 14.7.2, "Accessing Files in the Default or in a Specified Directory",
on page 852 for general information on file handling in the default and in a specific
directory.
SOURce Subsystem