Rohde & Schwarz R&S SMW200A - TEST Subsystem

Remote Control Commands
R&S
®
SMW200A
1247User Manual 1175.6632.02 ─ 30
14.22 TEST Subsystem
The TEST subsystem contains the commands for performing test routines directly at
the hardware assemblies.
The selftetst responses with a 0 if the test is performed successfully, otherwise a value
other than 0 is returned. None of the commands of this system has a *RST value.
:TEST:BASeband?....................................................................................................... 1247
:TEST:BASeband:LOG?............................................................................................... 1247
:TEST:BB:BNC:CONNection?........................................................................................1248
:TEST:BB:BNC:DESTination..........................................................................................1248
:TEST:BB:BNC:LOG?...................................................................................................1248
:TEST:BB:BNC:SOURce...............................................................................................1249
:TEST:BB:GENerator:ARBitrary.....................................................................................1249
:TEST:BB:GENerator:FREQuency................................................................................. 1249
:TEST:BB:GENerator:GAIN...........................................................................................1249
:TEST:BB:GENerator:SOURce...................................................................................... 1250
:TEST:BB:GENerator:STATe..........................................................................................1250
:TEST<hw>:DIRect:BLOCk:READ?............................................................................... 1250
:TEST<hw>:DIRect:BLOCk:WRITe................................................................................ 1251
:TEST<hw>:ALL:STARt................................................................................................ 1251
:TEST<hw>:ALL:RESult?..............................................................................................1251
:TEST:BASeband?
Queries the result of the baseband selftest.
Return values:
<TestBbError> 0 | 1 | RUNning | STOPped
Example:
:TEST:BASeband?
// 0
// the test succeeded
Usage: Query only
Manual operation: See "Execute Baseband Selftest" on page 1285
:TEST:BASeband:LOG?
Queries the log message reported during the baseband test.
This is a password-protected function. Unlock the protection level 1 to access it.
Return values:
<TestBasebandLog> string
Example:
SYSTem:PROTect1 0,123456
TEST:BB:BASeband:LOG?
// queries the reported message
Usage: Query only
TEST Subsystem