Rohde & Schwarz R&S SMW200A - Page 1251

Remote Control Commands
R&S
®
SMW200A
1251User Manual 1175.6632.02 ─ 30
<SubAddr> integer
<Addr> integer
<Len> integer
Return values:
<DataBlock> string
Example:
TEST:DIR:BLOC:READ? 'TEST_SCPI',0,0,8
Usage: Query only
:TEST<hw>:DIRect:BLOCk:WRITe <BoardName>, <SubAddress>, <StartAddress>,
<DataBlock>
Direct mode for programming the blocks of the hardware assemblies directly.
The respective hardware assembly responds directly to the command; any safety
mechanisms are bypassed. This function is only available via remote control.
Setting parameters:
<BoardName> string
<Board>, <SubAddr>, <Addr>, <Data>
<SubAddress> integer
<StartAddress> integer
<DataBlock> string
Example:
TEST:DIR:BLOC:WRIT 'TEST_SCPI',0,0,#1812345678
Usage: Setting only
:TEST<hw>:ALL:STARt
Usage:
Event
Starts the selftest. Use the command :TEST<hw>:ALL:RESult? to query the result.
:TEST<hw>:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with :TEST<hw>:ALL:
STARt.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST: STOPped
Usage: Query only
TEST Subsystem