Configuring the Internal Baseband Source
R&S
®
SMW200A
370User Manual 1175.6632.02 ─ 30
Access:
1. Enable and load a multi-segment waveform in the ARB, see Chapter 5.10.3, "Multi-
Segment Settings", on page 357.
2. Select "Baseband > ARB > Trigger In (MSW)".
The "Next Segment Trigger In" section comprises the settings necessary to adjust
the trigger for switching between the segments of a multi-segment waveform. The
parameters displayed depend on the selected trigger source.
Settings:
Current Segment/Current Segment Index...................................................................370
Segment......................................................................................................................370
Next Segment Mode................................................................................................... 371
Next Segment Source.................................................................................................372
Level Mode..................................................................................................................372
Execute Next Segment............................................................................................... 372
Sequencing List...........................................................................................................372
Trigger Example..........................................................................................................373
Current Segment/Current Segment Index
Indicates the waveform segment (segment filename and index) that is output.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment? on page 1038
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NAME? on page 1039
Segment
Selects the waveform segment to be output after the segment indicated as "Current
Segment". This parameter determines the start segment when switching on the ARB
and enables switching over to any other segment.
Generating Multi-Segment Waveform Files
To Next Page
Loading...