Rohde & Schwarz R&S SMW200A - LXI Settings; LXI Status Settings

Network Operation and Remote Control
R&S
®
SMW200A
795User Manual 1175.6632.02 ─ 30
The "QR Code" dialog shows the current instrument address (IP address) in quick
response (QR) format.
This functionality provides fast access to the instrument via VNC with, for example, a
smartphone or a tablet.
See Chapter 13.9.3, "How To Set Up a Remote Operation from a Smart Device",
on page 834.
13.5 LXI Settings
On the R&S SMW the LXI functionality is already installed and enabled, see LXI Status
Settings. Thus, the instrument can be accessed via any web browser (like the Micro-
soft Internet Explorer) to perform the following tasks:
●
Modifying network configurations
●
Remote control the instrument
●
Performing SCPI remote diagnostics
The LAN settings are configured using the instrument's LXI browser interface descri-
bed in Chapter 13.5.2.1, "LAN Configuration", on page 798.
13.5.1 LXI Status Settings
Access:
► Select "System Config > Setup > Remote Access > LXI Status...".
LXI Settings