Rohde & Schwarz R&S SMW200A - Execute Next Segment; Level Mode; Next Segment Source; Sequencing List

Configuring the Internal Baseband Source
R&S
®
SMW200A
372User Manual 1175.6632.02 ─ 30
"Sequencer"
The waveform files are processed according to the order and repeti-
tion cycles defined in the special sequencing list file (*.wvs)
assigned to the multi-segment waveform file.
This “play list” is defined in the Multi-Segment Waveform Sequencing
dialog.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe on page 1042
Next Segment Source
Determines whether the next segment is switched upon receiving of an external trigger
signal or upon executing of software next segment trigger (see Figure 5-30).
This parameter is disabled, if a sequencing play list is used.
"Internal"
Switch over to any segment is triggered manually with the "Execute
Next Segment" function.
"External Global Next Segment"
The trigger event for switching to the next segment is input as config-
ured on one of the USER x connectors.
See also Chapter 12.2, "Configuring Local and Global Connectors",
on page 714.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:SOURce on page 1039
Level Mode
Sets how the instrument levels the individual segments in a multi-segment signal. The
parameter is important, if waveforms with different crest factors are used.
"Highest"
All segments are output at the highest available crest factor.
"Unchanged"
Each segment is output with the crest factor defined in its waveform
file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:LMODe on page 1040
Execute Next Segment
For "Next Segment Source = Internal", triggers manually switch over to the subsequent
segment in the multi-segment file. The subsequent segment can be any segment
within the multi-segment file and is defined by the parameter "Segment"
This parameter is disabled, if a sequencing play list is enabled.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:EXECute on page 1039
Sequencing List
Opens a dialog box for defining the “play lists”, see Chapter 5.10.3.4, "Multi-Segment
Waveform Sequencing", on page 365.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:SEQuence:SELect on page 1040
Generating Multi-Segment Waveform Files