Rohde & Schwarz R&S SMW200A - RF Frequency Settings

Configuring the RF Signal
R&S
®
SMW200A
462User Manual 1175.6632.02 ─ 30
8.4.1 RF Frequency Settings
Access:
► Select "RF" > "RF Frequency" > "Frequency".
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
● The frequency overrange, If an R&S SZU is connected, see "Frequency Over-
range" on page 464.
The remote commands required to define the settings are described in Chap-
ter 14.19.6, "SOURce:FREQuency Subsystem", on page 1124.
Settings
Frequency................................................................................................................... 462
Offset...........................................................................................................................463
Multiplier......................................................................................................................463
Converter Mode.......................................................................................................... 463
Frequency Overrange................................................................................................. 464
└ Frequency Overrange Active........................................................................ 464
└ Minimal Frequency........................................................................................465
└ Maximal Frequency.......................................................................................465
User Variation..............................................................................................................465
└ Variation Active............................................................................................. 465
└ Variation Step................................................................................................465
Frequency
Sets the RF frequency.
This frequency is output at the RF A/RF B connector. It does not consider an Offset or
multiplication factor (Multiplier).
See Chapter 8.4.4.1, "Displayed RF Frequency and Level Values with Downstream
Instruments", on page 472.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
Configuring RF Frequency and Level