Rohde & Schwarz R&S SMW200A - Defining the RF Signal State on Power on; Display Update Settings

General Instrument Functions
R&S
®
SMW200A
712User Manual 1175.6632.02 ─ 30
12.1.3 Display Update Settings
Access:
► Select "System Config > Setup > User Interface > Start/Stop Display Update".
This dialog enables you, to deactivate updating the display.
The remote command to switch off the display update is described in Chapter 14.12,
"DISPlay Subsystem", on page 874.
Display Update is
Disables the automatic refreshing of the displayed values.
Remote command:
:DISPlay:UPDate on page 875
12.1.4 Defining the RF Signal State On Power On
As additional functions for the level settings, you can determine the state of the RF sig-
nal, and the level display in the status bar when you turn on the R&S SMW.
Power-On/EMF settings
Access:
► Select "RF" > "RF Level" > "Power-On / EMF".
The "Power-On/EMF" dialog contains all settings for configuring the power-on
behavior and the level display.
Customizing the User Interface