Rohde & Schwarz R&S SMW200A - Fading and Baseband Configuration Settings

Signal Routing and System Configuration
R&S
®
SMW200A
125User Manual 1175.6632.02 ─ 30
● Fading and Baseband Configuration Settings...................................................... 125
● I/Q Stream Mapper Settings..................................................................................132
● External RF and I/Q Settings................................................................................ 135
● Overview............................................................................................................... 152
4.4.1 Fading and Baseband Configuration Settings
Access:
► Use one of the following:
● Select "Taskbar > System Config > System Configuration > Fading/Baseband
Config"
● Select "Block Diagram > Fading > System Configuration > Fading/Baseband
Config"
● Select "Block Diagram > I/Q Stream Mapper > System Configuration > Fading/
Baseband Config"
● On the instrument front panel, press [SETUP].
Select "System Configuration > Fading/Baseband Config"
The dialog comprises the settings required to configure the signal routing up to the
"I/Q Stream Mapper". A preview diagram shows a detailed view of the signal pro-
cessing for the currently selected configuration, together with a short description of
the possible application of this configuration.
If you are familiar with other Rohde & Schwarz signal generators, like the R&S SMU,
you expect that the block diagram displays the signal routing as it is done on the pre-
view diagram. Consider, however, that if in "Fading/Baseband Configuration > Mode >
Standard" this behavior is assured, for higher MIMO modes in "Mode > Advanced" the
block diagram is an abstract representation of the configuration.
System Configuration Settings