Rohde & Schwarz R&S SMW200A - How to Install or Deinstall an Extension; Using the Security Settings

General Instrument Functions
R&S
®
SMW200A
752User Manual 1175.6632.02 ─ 30
12.5.2 How to Install or Deinstall an Extension
This example explains how to perform the required steps at the instrument.
Use a USB flash drive to provide the extension files at one of the USB interfaces of the
instrument.
To load and install an extension
1. Select "System Config > Setup > Instrument Assembly > Manage Extensions...".
2. Select "Install Extension".
3. In the "Select Extensions Directory", select the file from the USB flash drive.
4. Select "Install".
The R&S SMW embeds the extension files in the instrument.
Note: If the file is not complete, or the filename is not correct, the R&S SMW aborts
the import and displays a warning.
5. In the "Manage Extensions" dialog, select "Reboot" to restart the R&S SMW.
After the reboot, the R&S SMW provides the loaded extension in the baseband
block.
To deinstall an extension
1. Select "System Config > Setup > Instrument Assembly > Manage Extensions...".
2. Select "Remove Extension".
3. In the "Select Extensions Directory", select the file.
4. Select "Remove".
The R&S SMW removes the corresponding files from the instrument.
Note: If you have installed a permanent option, the instrument displays a warning
message that you cannot remove this option.
5. Reboot the R&S SMW.
The extension is deleted.
12.6 Using the Security Settings
The protection function of the R&S SMW offers several levels to activate particular
functions like self-test or tests for service purposes specifically.
Protection
The five protection levels are automatically active on startup, the protection levels, that
means all protected functions are locked.
Using the Security Settings