Rohde & Schwarz R&S SMW200A - How to Create, Generate and Play Waveform Files

Configuring the Internal Baseband Source
R&S
®
SMW200A
311User Manual 1175.6632.02 ─ 30
5.7.3.5 Trigger, Marker and Clock Setting
These tabs provide standard settings.
For detailed description, see:
●
Chapter 5.5.2.1, "Trigger Settings", on page 252
●
Chapter 5.5.2.2, "Marker Settings", on page 256
●
Chapter 5.5.2.3, "Clock Settings", on page 258
●
Chapter 5.5.2.4, "Local and Global Connectors Settings", on page 259
The following settings are specific to the ARB dialog.
Marker Mode............................................................................................................... 311
Delay (Time)................................................................................................................ 311
Marker Mode
Basic marker configuration for up to three marker channels. The contents of the dialog
change with the selected marker mode.
Use the settings to define the shape and periodicity of the markers. See Regular
Marker Output Signals for description of the regular marker signals.
Note: The marker trace in the waveform file remains unchanged in any case. It is not
overwritten, even if something else than Unchanged has been selected.
The instrument routes the generated marker signals to the selected output connectors.
See also Chapter 12.2, "Configuring Local and Global Connectors", on page 714.
"Unchanged"
The marker signal remains unchanged as defined in the waveform
file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:MODE on page 1067
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider
on page 1068
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 1069
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern on page 1068
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:OFFTime on page 1067
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:ONTime on page 1067
Delay (Time)
Shows the marker delay time in microseconds, milliseconds or seconds depending on
the set marker delay.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DINSec? on page 1069
5.7.4 How to Create, Generate and Play Waveform Files
This section provides step-by-step instructions on configuring and using the provided
settings. For details on individual functions and settings, see Chapter 5.7.3, "ARB Set-
tings", on page 301.
Using the Arbitrary Waveform Generator (ARB)