Rohde & Schwarz R&S SMW200A - Password Management

General Instrument Functions
R&S
®
SMW200A
762User Manual 1175.6632.02 ─ 30
Support of version 1.0 and 2.0 is additional to the current SMB protocol version sup-
ported in the firmware. This firmware supports SMB protocol versions up to version 4.
SMB 1.0/2.0 Client ← Samba Services
Activates support of the SMB client compatible with SMB protocol versions 1.0 and 2.0.
SMB 1.0/2.0 Server ← Samba Services
Activates support of the SMB server compatible with SMB protocol versions 1.0 and
2.0.
Security Password
Enters the password that is required to enable or to disable the settings protected by a
security password. Default is 123456.
How to:
●
"Disabling the LAN interface" on page 765
●
"Disabling LAN services" on page 765
●
"Changing the default security password" on page 765.
Accept
Applies the modified settings, provided the security password is entered and correct.
12.6.4 Password Management
Access:
1. Select "System Config > Setup > Security > Security > Password Management >
User Password".
In this tab, you can assign the security and a user-defined password.
Using the Security Settings