Rohde & Schwarz R&S SMW200A - QR Code

Network Operation and Remote Control
R&S
®
SMW200A
794User Manual 1175.6632.02 ─ 30
Access:
► Select "System Config > Remote Access > HUMS".
The dialog provides settings to configure settings of the health and utility monitor-
ing system (HUMS) of the R&S SMW.
The remote commands required to define these settings are described in Chap-
ter 14.11, "HUMS Remote Control Commands", on page 871.
Settings
State............................................................................................................................794
Delete History..............................................................................................................794
Export History..............................................................................................................794
State
Activates HUMS.
Data is only recorded, if HUMS is activated. If deactivated, already recorded data can
still be retrieved.
Remote command:
DIAGnostic:HUMS:STATe on page 873
Delete History
Deletes all information from the HUMS service including the device history.
Remote command:
DIAGnostic:HUMS:DEVice:HISTory:DELete:ALL on page 873
Export History
Triggers an export of the logged data of the HUMS service into a *.zip file.
A standard file dialog opens, to save the log file. By default, the file is saved to the
directory /var/user/.
Remote command:
DIAGnostic:HUMS:DEVice:HISTory? on page 872
DIAGnostic:HUMS:SAVE on page 873
13.4.8 QR Code
Access:
► Select "System Config > Remote Access > QR Code".
Remote Access Settings