Rohde & Schwarz R&S SMW200A - I;Q Stream Mapping

Remote Control Commands
R&S
®
SMW200A
919User Manual 1175.6632.02 ─ 30
The total number of enabled channels on all HS DIG I/Q interface must not exceed 8.
Parameters:
<DigIqHsBBMM2Cha>CH0 | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8
Example: See Example "Generating digital signals" on page 907.
Options: R&S SMW-K19
Manual operation: See "HS Channels per" on page 131
:SCONfiguration:DUPLicate[:STReam] <DuplicateStream>
In a 3x1x1 or 4x1x1 configuration, creates a copy of each stream. Generates are a
total number of 6 or 8 streams, where 4 of them can be signals with real-time data
source.
Parameters:
<DuplicateStream> 0 | 1 | OFF | ON
*RST: 0
Example:
:SCONfiguration:APPLy
:SCONfiguration:MODE ADV
:SCONfiguration:FADing SISO3X1X1
:SCONfiguration:DUPLicate:STReam 1
:SCONfiguration:APPLy
Options: R&S SMW-K550
Manual operation: See "Duplicate Streams" on page 131
:SCONfiguration:APPLy
Assigns and confirms the settings.
Example:
See Example "Distributing the I/Q streams to the output connec-
tors" on page 904.
Usage: Event
Manual operation: See "Apply" on page 132
See "Ok" on page 132
14.18.3 I/Q Stream Mapping
Option: R&S SMW-B10 for commands with the keyword FADer<ch>.
The following commands configure the I/Q stream mapper.
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:CHANnel<di>:STReam<st>:STATe............. 920
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:STReam<st>:STATe.................................. 920
:SCONfiguration:OUTPut:MAPPing:RF<ch>:STReam<st>:STATe....................................... 920
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:STReam<st>:STATe..................................920
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:STReam<st>:STATe.............................. 920
SCONfiguration Subsystem